Vrrp Timers Advertise - Edge-Core ES4612 Management Manual

4
Command Line Interface
Command Usage
• A router that has a physical interface with the same IP address as that used
for the virtual router will become the master virtual router. The backup router
with the highest priority will become the master router if the current master
fails. When the original master router recovers, it will take over as the active
master router again.
• If two or more routers are configured with the same VRRP priority, the router
with the higher IP address is elected as the new master router if the current
master fails.
• If the backup preempt function is enabled with the vrrp preempt command,
and a backup router with a priority higher than the current acting master
comes on line, this backup router will take over as the new acting master.
However, note that if the original master (i.e., the owner of the VRRP IP
address) comes back on line, it will always resume control as the master.
Example
Console(config-if)#vrrp 1 priority 1
Console(config-if)#
Related Commands
vrrp preempt (4-315)

vrrp timers advertise

This command sets the interval at which the master virtual router sends
advertisements communicating its state as the master. Use the no form to restore
the default interval.
Syntax
vrrp group timers advertise interval
no vrrp group timers advertise
• group - Identifies the VRRP group. (Range: 1-255)
• interval - Advertisement interval for the master virtual router.
(Range: 1-255 seconds)
Default Setting
1 second
Command Mode
Interface (VLAN)
Command Usage
• VRRP advertisements from the current master virtual router include
information about its priority and current state as the master.
4-314