Table of Contents
Advertisement
Servicing Notes
Servicing should be carried out annually by a competent person such as a CORGI
registered engineer. This is a condition of the BFM Europe Ltd. extended
guarantee schemes.
The service should include visually checking the chimney and fire opening for
accumulations of debris and a smoke test to check for a positive up-draught in the
chimney.
The condition of the coals should be checked and if necessary the whole set
should be replaced with a genuine replacement set.
The burner assembly is designed to be removed as a complete unit for ease of
access. After any servicing work a gas tightness check must always be
carried out.
Manual Control Fires – For Diagrams refer to Section 2
4.1
Removing the burner assembly from the fire.
4.1.1
Prepare work area (lay down dust sheets etc.)
4.1.2
To remove the fascia, open the controls access door at the bottom of
the fascia. This will allow access to the fascia retaining screws, located
at the bottom left and right hand sides of the firebox. Remove these
screws and lift the fascia clear. Remove the loose coals from the fuel
bed and the front ceramic rail. Remove the front ceramic from the rail.
Unscrew the two pozi-driv fixing screws which secure the burner heat
shield and remove it from the fire.
4.1.3
Isolate the gas supply and remove the inlet pipe from the appliance
inlet elbow. Unscrew and remove the four screws which retain the
burner. Remove the burner assembly from the fire.
4.1.4
To refit the burner assembly. Push the base of the control panel fully
into the fire and secure with the four screws. Refit the gas supply pipe
and carry out a gas tightness test. Refit the coals referring to section 3
for the correct coal layout. The fascia can now be replaced by hooking
it over the top flange of the mounting frame and securing via the two
screws, accessed through the controls opening door.
SECTION 4
MAINTENANCE
34
Advertisement
Table of Contents
