Table of Contents
Advertisement
o)
Fit a screwed nipple on to each of the cables and pull hand tight up
against the tensioning screw, then secure each nipple with a flat
bladed screwdriver. See fig. 15 below
Fig. 15
p)
Evenly tighten the tensioning nuts to tension both cables and pull the
fire snugly against the wall. Do not overtighten, it is only necessary to
pull the seal up against the sealing face of the wall, it does not need to
be compressed. Check that there are no gaps behind the seal.
q)
With the fire securely in place, if a concealed gas connection has been
made through either of the access holes in the sides of the fire, the
holes should be closed around the pipe to prevent leakage of air
through the gap around the pipe, refer to page 17.
r)
Refit the burner. Fit the four retaining screws on manual control models
and two retaining screws on remote control models. Check that the
burner is correctly locked into position.
s)
Secure the firebox into the mounting plate with the four off M5 screws.
t)
Before making the final gas connection, thoroughly purge the gas
supply pipework to remove all foreign matter, otherwise serious
damage may be caused to the gas control valve on the fire.
19
Advertisement
Table of Contents
