Table of Contents
Advertisement
4.7.3
Loosen the pilot nut and remove the two screws retaining the pilot
assembly. Unscrew the thermocouple from the gas valve.
4.7.4
Re-assemble in reverse order, Refit the coals referring to section 3
for the correct coal layout. The fascia can now be replaced by hooking
it over the top flange of the mounting frame and securing via the two
screws, accessed through the controls opening door.
4.8
Replacing the Batteries (Within the Radio Frequency Receiver)
4.8.1
Prepare work area (lay down dust sheets etc.)
4.8.2
To remove the fascia, open the controls access door at the bottom of
the fascia. This will allow access to the fascia retaining screws, located
at the bottom left and right hand sides of the firebox. Remove these
screws and lift the fascia clear.
4.8.3
The RF receiver is located on the right hand side of the product, below
the burner assembly. Slide the RF reciever out, slide the battery cover
off and replace the batteries as necessary.
4.8.4
The fender and ash pan cover can now be re-positioned. Refit the trim.
NB
The handset uses one LR61 (9v) and should be replaced by
removing the cover on the rear of the handset.
ENSURE THE BATTERIES ARE CONNECTED TO THE CORRECT POLARITY
POSITVE (+), NEGATIVE (-)
37
Advertisement
Table of Contents
