Table of Contents
Advertisement
c)
The firebox mounting plate should then be secured to the fireplace
opening as created in section 2.3, via the mounting holes as indicated
below in Fig. 8.
Fig. 8
20mm
d)
Drill 8 off holes in the positions as indicated, and secure the firebox
mounting plate to the fireplace opening. Use all eight fixing points to
ensure a satisfactory seal is achieved. It may be necessary to seal the
plate with tape if required.
e)
Remove the burner engine from the fire as shown overpage in Fig. 9 &
Fig. 10 (Manual & Remote control versions respectively).
7mm Base
Centre Hole
Only
430mm
215mm
14
500mm
250mm
20mm
Advertisement
Table of Contents
