Operation
This section provides information and procedures for operating the projector.
Projector LED Status Indicators
LED
Solid Green
On
Solid Yellow
Standby mode
Solid Green,
AC is On
Yellow and Red
Flashing Green
Warm up
Flashing Yellow
Cool down
Flashing Red
Alarm or warning preset
Flashing Green
AC ON to Standby
and Yellow
Flashing Green,
Recovery
Yellow and Red
Turn the Projector On
Do not attempt to turn the projector On if the AC supply is not within the specified voltage
range. Failure to comply could result in death or serious injury.
1. Set the breaker switch on the projector baseplate to the On position.
2. When the projector reaches standby, tap the Home tab > Power button.
Turn the Projector Off
1. Tap the Home tab.
2. Tap the Power button. NOTE: When powering Off in preparation for inspection or
maintenance, always disconnect from AC and set the projector breaker to the Off position.
D4K2560 User Manual
020-101076-01 Rev. 1 (06-2013)
State
Description
The video electronics are on, the lamp is On.
Video Electronics are Off, Lamp is Off.
The MCPU board software has not started
initialization.
Video Electronics are initializing, lamp is striking
and warming up.
Lamp is off, video electronics and lamp is cooling
down.
There is a problem with the projector that needs to
be addressed.
The MCPU board software has started initialization.
Projector is in the recovery state.
27