Introduction; Safety And Warning Guidelines - Christie D4K2560 User Manual

Introduction

This manual is intended for professionally trained operators of Christie high-brightness projection
systems. These operators are qualified to replace the lamp and air filter, but should not attempt to
install or service the projector.
Only accredited Christie technicians who are knowledgeable about the hazards associated with high-
voltage, ultraviolet exposure, and the high temperatures generated by the projector lamp are
authorized to assemble, install, and service the projector.

Safety and Warning Guidelines

This projector must be operated in an environment that meets the operating range specification. Use
only the attachments and/or accessories recommended by Christie. Use of others may result in the
risk of fire, shock or personal injury.
Failure to comply with the following could result in death or serious injury:
• Never look directly into the projector lens or at the lamp. The extremely high brightness
• FIRE HAZARD! Keep hands, clothes, and all combustible material away from the
Failure to comply with the following could result in minor or moderate injury:
• Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
• The American Conference of Governmental Industrial Hygienists (ACGIH) recommends
D4K2560 User Manual
020-101076-01 Rev. 1 (06-2013)
can cause permanent eye damage. For protection from ultraviolet radiation, keep all
projector housings intact during operation. Protective safety gear and safety goggles are
recommended when servicing.
concentrated light beam of the lamp.
occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square
centimeters of effective UV radiation. A workplace evaluation is advised to assure
employees are not exposed to cumulative radiation levels exceeding the government
guidelines for your area. Be aware that some medications are known to increase
sensitivity to UV radiation. NOTE: During maintenance and cleaning operations, the
instructions define that the unit is not to be operational, thus the lamps will not be
active and there will be no emissions.
1