Setting Date, Time And Location - Cisco Codec C Series Getting Started Manual

Cisco TelePresence Video Systems
Contents

Setting date, time and location

(when not set by a provisioning system)
You should check that the date and time settings are correct
when you set up your video conference system. the system
uses this information for example to time stamp messages
transmitted to gatekeepers and other network elements.
You can find the time in the top right corner of the touch
controller display.
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
1. tap Settings > Date, Time &
2. tap 24h or
3. tap dd.mm.yy,
Format you prefer.
4. Select the
list of available zones by tapping the - or + signs.
5. Set Date & Time Mode
to be regularly updated; otherwise, select Manual.
if you select Manual, enter the correct value for Hour, Minute,
Year, Month, and Day. tap the plus and minus signs to
increase or decrease a value.
if you select Auto, the NtP server address can be automati-
cally obtained from the network (set the
Auto) or you can enter the
(set NTP Mode
6. tap Save
saving.
7. tap Exit to return to the home menu.
Confirguration Configuration
Location.
12h to select the Time Format you prefer.
mm.dd.yy or yy.mm.dd to select the
Time Zone your system is in. Step through the
to Auto if you want time and date
NTP Mode
NTP Server address yourself
to Manual).
to save the changes, or Undo to leave without
16
Appendices
Date
to
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts