Specify The Ip Address And Default Gateway For The Eth0 Interface; Step 1 - Cisco MARS Install And Setup Manual

Chapter 5 Initial MARS Appliance Configuration
To change the password associated with the pnadmin account, follow these steps:
Establish a console connection to the MARS Appliance; for options and details see

Step 1

Console Connection, page
Note
Log in using the system administrative account and password (pnadmin/pnadmin).
Step 2
The system displays the [pnadmin]$ prompt.
Confirm that the following information is displayed above the [pnadmin]$ prompt:
Step 3
Last login: Mon May
[pnadmin]$
At the
Step 4
Note When you boot the system for the first time, it is not configured. Logging in as pnadmin allows you to
configure the system.
The system displays the
At the
Step 5
Passwords are case sensitive. They can contain up 64 alphanumeric characters and special characters (!,
@, #, etc.). However, a password cannot contain spaces, single quotes, double quotes, or parenthesis.
The system displays the
At the
Step 6
The system displays the [pnadmin]$ prompt.

Specify the IP address and Default Gateway for the Eth0 Interface

Before you can connect to the appliance and administer it using the web interface or a SSH client, you
must configure the appliance so that it can be reached by other hosts on your network.
Before you specify the interface settings, verify that eth0 is not connected to the network.
Establish a console connection to the MARS Appliance; for options and details, see
Step 1
Console Connection, page
Log in using the system administrative account and the new password specified in
Step 2
Password of the System Administrative Account, page
The system displays the [pnadmin]$ prompt.
OL-14672-01
5-4.
If the MARS Appliance is not configured (that is, it is new or has been re-imaged), the system
displays the system information—including the software version.
2 10:22:34 2005 from <host_address>
CS MARS - Mitigation and Response System
? for list of commands
prompt, enter passwd.
[pnadmin]$
New password:
prompt, enter the new password.
New password:
Retype new password:
Retype new password:
5-4.
Configuring Basic Network Settings at the Command Line
prompt.
prompt.
prompt, re-enter the new password.
5-6.
Install and Setup Guide for Cisco Security MARS
Establishing a
Establishing a
Change the Default
5-7