Affixing Labels - H3C S12500 Installation Instructions Manual

Figure B-4 Writing direction of the label

Affixing Labels

After printing or writing the label, remove the label from the bottom page and affix it to the signal cable,
or the identification plate of the power cable.
Affixing the label to the signal cable
The steps to affix the label to the cable are shown in Figure B-5, Figure B-6 and Figure B-7. The finished
labels should be on the right or top of the cables, according to different cabling methods. The left part of
the figures shows the method to affix the label when the cable is laid vertically, while the right part of the
figures shows the method to affix the label when the cable is laid horizontally.
The label is affixed 2cm from the connector on the signal cable. In special cases, for example, to avoid
cable bent or affecting other cables, other positions are allowed to affix the labels.
1) Stick the label to the proper position on the cable, fold the narrow part of the label according to the
directions shown in Figure B-5.
Figure B-5 Stick the label onto proper position of the signal cable
Fold to right
The length of the narrow part is based on an external cable diameter of 2.6mm, after this part has been
stuck to the back of the label, it may not overlap the entire printed part.
2) Fold the printed part along the dotted line according to the directions shown in Figure B-6.
Cable
Stick side
Fold down
Cable
Stick side
B-5