H3C S12500 Quick Start Manual

H3C S12500 Quick Start Manual

Ethernet interface configuration examples
Hide thumbs Also See for S12500:

Advertisement

Quick Links

H3C S12500 Ethernet Interface Configuration
Examples
Copyright © 2013 Hangzhou H3C Technologies Co., Ltd. All rights reserved.
No part of this manual may be reproduced or transmitted in any form or by any means
without prior written consent of Hangzhou H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S12500 and is the answer not in the manual?

Questions and answers

Summary of Contents for H3C S12500

  • Page 1 H3C S12500 Ethernet Interface Configuration Examples Copyright © 2013 Hangzhou H3C Technologies Co., Ltd. All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of Hangzhou H3C Technologies Co., Ltd.
  • Page 2 Contents Introduction ··································································································································································· 1   Prerequisites ·································································································································································· 1   Example: Configuring Ethernet interfaces ·················································································································· 1   Network requirements ······················································································································································ 1   Requirements analysis ······················································································································································· 1   Software version used ······················································································································································ 2   Configuration restrictions and guidelines ······················································································································· 2   Configuration procedures ················································································································································ 2  ...
  • Page 3 Introduction This document provides Ethernet interface configuration examples. Prerequisites The configuration examples in this document were created and verified in a lab environment, and all the devices were started with the factory default configuration. When you are working on a live network, make sure you understand the potential impact of every command on your network.
  • Page 4 The half duplex mode cannot be configured for Ethernet interfaces. • • For interfaces to operate correctly, H3C recommends using the same rate and duplex mode settings for interfaces at both ends of a link. Configuration procedures # Set the rate to 100 Mbps for interface GigabitEthernet 3/0/2, and configure the interface to operate in full duplex mode.
  • Page 5 Media type is twisted pair, Port hardware type is 1000_BASE_T 100Mbps-speed mode, full-duplex mode Link speed type is force link, link duplex type is force link Flow-control is not enabled The Maximum Frame Length is 9216 Broadcast MAX-ratio: 100% Unicast MAX-ratio: 100% Multicast MAX-ratio: 100% Allow jumbo frame to pass PVID: 1...
  • Page 6 GigabitEthernet3/0/4 port link-mode bridge speed 100 Related documentation H3C S12500 Routing Switch Series Interface Configuration Guide • H3C S12500 Routing Switch Series Interface Command Reference •...

Table of Contents