Figure B-6 Fold up the label
Cable
Cable
Stick side
Stick side
Fold up
Fold to right
3)
After the printed part of the label has been folded up, the narrow part of the label should be covered
completely, as shown in Figure B-7.
Figure B-7 Appearance of affixed labels on signal cables
Cable
Cable
TO:
A03 33 33 33 33
Affixing the label to the power cable
Remove the label from the bottom page, then affix it to the identification plate on the cable tie. The label
should be stuck to the rectangular flute, and should be stuck to only one side of the identification plate.
Make sure to affix the labels on the same side of the identification plates. The cable ties are bundled at
2cm from the connectors, and other positions are allowed in special circumstances.
Cable ties should be bundled on both ends of a cable. After the bundling, the finished identification plate
should be on top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling.
Make sure the label is facing out, as shown in Figure B-8.
B-6