H3C S12500 Installation Instructions Manual page 81

|<5> 115200
|<0> Exit
==========================================================================
Enter your choice(0-5):1
Step3 Select the appropriate downloading speed as needed. For example, enter 1 to select the downloading
speed of 9600 bps.
The default baud rate of the console port is 9600 bps. The system uses the default setting at reboot
even if the baud rate was modified.
Step4 At the prompt displayed in the last step, change the baud rate on the console terminal to the same one
selected for software downloading, disconnect the terminal and connect it again, press Enter, and the
terminal will access the serial interface submenu again:
===========================<Enter Serial SubMenu>==========================
|Note:the operating device is cfa0
|<1> Download Application Program To SDRAM And Run
|<2> Update Main Application File
|<3> Update Backup Application File
|<4> Update Secure Application File
|<5> Update User Private File
|<6> Modify Serial Interface Parameter
|<0> Exit To Main Menu
==========================================================================
Enter your choice(0-6):2
After changing the baud rate, you must close the terminal emulation program and start it again for
at least once in order to validate the new baud rate.
In a Windows 98 operating system environment, you can perform the operations of disconnection
and reconnection after changing the baud rate. In a Windows 2000 operating system, however,
you must disconnect the terminal before setting the baud rate and connect the terminal after
finishing the work.
Step5 Select the operation to be implemented. For example, enter 2 to download the file into the switch, press
Enter, and the system will display the following information on the terminal:
Please Select File .
XMODEM downloading ...CCC
5-11
|
|
|
|
|
|
|
|
|
|