Adjusting An Image Manually - FLIR InfraCAM User Manual

8.10

Adjusting an image manually

General
If you want to analyze an object with many different temperatures, you can use the
colors of the scale on different parts of the object.
In the left image below a correct analysis of the left cable is difficult to make if you
only auto-adjust the image. You can analyze the left cable more in detail if you increase
or decrease
the maximum temperature level;
■
the minimum temperature level;
■
the maximum and minimum temperature level at the same time.
■
Figure
This figure shows two infrared images of cable connection points.
In the image to the left, the image is auto-adjusted. In the right image the maximum
and minimum temperature levels have been changed to temperature levels near the
object. In the temperature scale to the right of each image you can see how the
temperature levels were changed.
10577503;a1
SEE ALSO
For procedures about how to adjust the image manually, see these sections:
Section 8.10.1 – Increasing or decreasing the maximum temperature level on
■
page 38
Section 8.10.2 – Increasing or decreasing the minimum temperature level on
■
page 39
Section 8.10.3 – Changing both the maximum and minimum temperature level at
■
the same time on page 40
Publ. No. 1558299 Rev. a200 – ENGLISH (EN) – February 12, 2007
8 – Operating the camera
37
8