Using The Combined Power Supply & Battery Charger To Charge The Battery When It Is Outside The Camera - FLIR InfraCAM User Manual

8.3.2 Using the combined power supply & battery charger to charge the
battery when it is outside the camera
NOTE
For the clarity of the procedure, the 'combined power supply & battery charger' is
called 'power supply' below.
Procedure Follow this procedure to use the power supply to charge the battery when it is outside
the camera:
1
2
3
4
NOTE The battery has a battery condition indicator. When the green light is continuous, the
battery is fully charged.
SEE ALSO
For information about the battery condition indicator, see section 5.6 – Battery con-
dition indicator on page 17.
Publ. No. 1558299 Rev. a200 – ENGLISH (EN) – February 12, 2007
Put the battery on a flat surface.
Connect the power supply cable plug to the connector on the battery.
Connect the power supply wall plug to a wall outlet box.
Disconnect the power supply cable plug when the green light of the battery
condition indicator is continuous.
8 – Operating the camera
29
8