Using The Combined Power Supply & Battery Charger To Charge The Battery When It Is Inside The Camera - FLIR InfraCAM User Manual

8 – Operating the camera
8.3.1
NOTE
Procedure
NOTE
8
SEE ALSO
28
Using the combined power supply & battery charger to charge the
battery when it is inside the camera
For the clarity of the procedure, the 'combined power supply & battery charger' is
called 'power supply' below.
Follow this procedure to use the power supply to charge the battery when it is inside
the camera:
1 To open the battery compartment lid, push down the locking mechanism.
2 Push the battery into the battery compartment.
3 Push the battery compartment lid into position.
4 On the battery compartment lid, open the rubber lid to find the connector
on the battery.
5 Connect the power supply cable plug to the connector on the battery.
6 Connect the power supply wall plug to a wall outlet box.
7 Disconnect the power supply cable plug when the green light of the battery
condition indicator is continuous.
The battery has a battery condition indicator. When the green light is continuous, the
battery is fully charged.
For information about the battery condition indicator, see section 5.6 – Battery
■
condition indicator on page 17.
For information about how to install and remove the battery, see section 8.1 – In-
■
stalling the battery on page 25 and section 8.2 – Removing the battery on page 26.
Publ. No. 1558299 Rev. a200 – ENGLISH (EN) – February 12, 2007