High Capacity Feeder Tests; Feed Test - Lexmark W820 Service Manual

High Capacity Feeder Tests

Feed Test

Use the Feed Test operation within the INPUT TRAY TESTS to verify that media can be
fed from a specific input source. No information is printed on the feed test pages since the
laser isn't engaged during this test.
Note: The feed test can be run using any of the paper sizes supported by the printer.
The pages are placed in the default output bin. However, the Feed Tests menu lets you
select the input source. Each of the installed sources is listed as an option within this
menu. For each source, the user has two choices:
•
•
While the page is being fed, the following message is displayed. The Power indicator
blinks while the page is being fed.
<input tray>
Feeding...
If Single is selected, no buttons are active during the feed test. However, if Continuous is
selected, Return or Stop can be pressed to cancel the test. While the test is being
cancelled, the following message is displayed.
<input tray>
Cancelling...
Note: <input tray> represents the input source selected for the Print Test. One of the
following sources is displayed: Tray 1, Tray 2, Tray 3, Tray 4, Tray 5.
4025 Options
Single (feed one sheet of media),
Continuous (continue feeding media until Return or Stop is pressed).
3-5
Diagnostic Aids