Lexmark W820 Service Manual page 183

Removal
1.
Remove the Mailbox Rear Cover.
2.
Lift the Mailbox off of the printer and set it down on the Front Cover.
3.
Disconnect P/J 812 (In Solenoid) from the Mailbox Control PWB.
4.
Remove the two screws securing the Tie Plate to the frame, and remove the Tie
Plate.
5.
Remove the two small brass screws securing the IN Gate Solenoid to the Rear
Lower Cover.
6.
Slide the Solenoid plunger out of the IN Gate Link and remove the IN Gate Solenoid
from the Mailbox frame.
Note: Do not lose the IN Gate Solenoid Spring or the two small brass screws.
Replacement
1.
Reinstall the IN Gate Solenoid Spring onto the Solenoid plunger.
2.
Slide the end of the Solenoid plunger into the slot in the IN Gate Link.
3.
Reinstall the Solenoid and attached IN Gate Link onto the frame, making sure the
tab on the Link fits into the slot in the frame.
4.
Use two small brass screws to secure the Solenoid to the frame.
5.
Reinstall the Tie Plate to the frame, and use two screws to secure the Tie Plate.
6.
Reconnect P/J 812 to the Mailbox Control PWB.
7.
Reinstall the Mailbox onto the printer.
8.
Reinstall the Mailbox Rear Cover.
4025 Options
4-41
Repair Information