Lexmark W820 Service Manual page 207

Removal
1.
Remove the HCF Rear Cover.
2.
Remove the HCF Feed Motor.
3.
Remove two screws securing the Take Away Bracket to the frame and remove the
Bracket (Figure 1).
4.
Remove the E-ring securing HCF Drive Gear 1 and the E-ring securing Tray 4 Drive
Gear 1 and slide both Gears off of the shafts (Figure 2).
5.
Remove the Drive Belt from the HCF Drive Pulley.
Replacement
1.
Reinstall the Drive Belt over the HCF Drive Pulley.
2.
Reinstall the HCF Drive Gear 1 and the Tray 4 Drive Gear 1 onto the respective
shafts, and use one E-ring to secure each gear (Figure 2).
3.
Reinstall the Take Away Bracket to the frame, making sure the bearing is still in place
on the end of the Feed Clutch, and use two screws to secure the Bracket (Figure 1).
4.
Reinstall the HCF Feed Motor.
5.
Reinstall the Rear Cover.
4025 Options
4-65
Repair Information