Lexmark W820 Service Manual page 179

Removal
1.
Remove the Paper Stopper.
2.
Remove the Mailbox Top Cover Assembly.
3.
Remove BIN Tray 10.
4.
Disconnect P/J 803 (Solenoid 9) from the Mailbox PWB.
5.
Loosen, do not remove, the screw securing Solenoid 9 to the Mailbox frame.
6.
Release the Solenoid plunger from the end of Gate 9, and remove Solenoid 9.
7.
Remove BIN Tray 9.
8.
Disconnect P/J 804 (Solenoid 8) from the Mailbox PWB.
9.
Loosen, do not remove, the secure securing Solenoid 8 to the Mailbox frame.
10.
Release the Solenoid plunger from the end of Gate 8, and remove Solenoid 8.
11.
Repeat steps 7 through 10 to access and remove the other Gate Solenoids.
Replacement
1.
Reinstall the lowest Solenoid number first (1 - 9) onto the Mailbox frame, making
sure you line up the positioning holes in the Solenoid bracket with the positioning
tabs on the frame.
2.
Insert the Solenoid plunger into the end of the Gate (see the insert in figure).
3.
Tighten the screw to secure the Solenoid to the frame.
4.
Reconnect the Solenoid P/J to the Mailbox Control PWB.
5.
Reinstall the BIN Tray you removed in order to reach the specific Solenoid.
6.
Repeat steps 1 through 5 to reinstall the remaining Solenoid(s) and BIN Tray(s).
7.
Reinstall the Mailbox Top Cover Assembly.
8.
Reinstall the Paper Stopper.
4025 Options
4-37
Repair Information