Lexmark W820 Service Manual page 162

Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Replacement
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
4-20
Service Manual
Disconnect P612 from the jack that is located at the rear of the printer.
Unhook and remove the Stopper.
Lift the Mailbox off of the Rack, and place the Mailbox on a level and stable surface.
Press in on the latches securing the Rack to the Left and Right Brackets and lift the
Rack up and off of the Brackets.
Remove the thumbscrew securing the Right Bracket to the printer, lift the Bracket up
to release the tabs, and remove the Bracket.
Remove the thumbscrew securing the Left Bracket to the printer, lift the Bracket up
to release the tabs, and remove the Bracket.
Remove the four screws securing the Foot Assembly to the Left Bracket and remove
the Foot Assembly.
Remove the screw securing the Spacer Foot to the Foot Assembly and remove the
Spacer Foot.
Remove the two screws securing Stand L to the Right Bracket and remove Stand L.
Remove the Stopper Foot from the Bracket Assembly - Foot.
Remove the Bracket Assembly - Foot from the base engine.
Rotate and lower the Foot Assembly Adjuster.
Rotate and raise the Foot Assembly Adjuster so you can slide the Bracket Assembly
- Foot under the base engine.
Once the Bracket Assembly - Foot is in position under the base engine, secure the
Bracket Assembly by sliding the Stopper Foot into the holes in the Bracket Assembly.
Reinstall the Spacer Foot to the Foot Assembly and use one screw to secure the
Foot to the Assembly.
Reinstall the Foot Assembly to the Left Bracket and use four screws to secure the
Assembly to the Bracket.
Attach the Left Bracket to the left side of printer by first inserting the two metal tabs
on the back of the Bracket into the two holes in the left side of the printer.
Slide the Left Bracket down to lock the tabs in place.
Use a thumbscrew to secure the Left Bracket to the printer.
Attach Stand L to the Right Bracket, and use two screws to secure Stand L.
Attach the Right Bracket to the right side of the printer by first inserting the two metal
tabs on the back of the Bracket into the two holes in the right side of the printer.
Slide the Right Bracket down to lock the tabs in place.
Use a thumbscrew to secure the Right Bracket to the printer.
Slide the legs of the Rack into the tops of the Left and Right Brackets.
Push down on the Rack until it locks into place.
Reinstall the Mailbox by carefully lowering the opening in the Mailbox support arm,
onto the pin at the top of the Rack.
Position the Stopper so when it is installed it blocks paper from exiting the right side
of the Mailbox bins.
Hook one end of the Stopper through the hole at the tip of Tray 1, and hook the other
end of the Stopper through the hole at the tip of Tray 10.
Plug P612 into the jack that is located at the rear of the printer.
4025 Options