Installation Overview - Extron electronics TouchLink TLP Pro 1020 Series User Manual

Installation
Overview
1.
2.
3.
4.
5.
Before starting, download and install the latest versions of the following software:
Global Configurator Plus and Global Configurator Professional — for setting up
…
and configuring the control processor and touchpanel.
GUI Designer — for designing layouts for Extron TouchLink Pro touchpanels and third
…
party touch interfaces.
See Configuration Software
Obtain the following network information from your network administrator:
DHCP status (On or Off). If DHCP is Off, you will also require
…
IP address
…
Subnet mask
…
Gateway
…
User name — by default these are either
…
Passwords — by default these are either
…
user).
MAC address — make a note of the touchpanel MAC address.
…
Mount and cable the units:
ATTENTION:
Do not power on the touchpanels or control processors until you have read
•
the Attention notice on
injector).
Ne branchez pas les écrans tactiles ou les contrôleurs avant d'avoir lu les mises
•
en garde page 10
Mount the units. There are several mounting options for TouchLink Pro touchpanels (see
…
Mounting on page 23).
Connect cables to the touchpanels. See
…
Series Rear Panel Features
Connect the power cords and power on all devices (see
…
Network and Power Injector Connector
or
Set up the Touchpanels for Network Communication:
Connect the PC that you will use for setup, the control processor, and the touchpanel to
…
the same Ethernet subnetwork.
Use the Setup Menu (see page 14) or the Toolbelt feature of Global Configurator Plus
…
and Global Configurator Professional to set the DHCP status and, if necessary, the IP
address, subnet mask, gateway, and related settings for the touchpanel.
Configure the Touchpanels — the Global Configurator Plus and Global Configurator
Professional Help File and the GUI Designer Help File provide step-by-step instructions and
detailed information. The Global Configurator Plus and Global Configurator Professional
Help File includes an introduction to the software and sections on how to start a project and
configuration.
TLP Pro 720 Series and TLP Pro 1020 Series • Installation Overview
on page 20.
or
admin user
extron (for admin) or the field is left blank (for
page 10 (12 VDC power supply) or on
(source d'alimentation 12 VCC) ou
TLP Pro 720 Series and TLP Pro 1020
(page 8).
on page 11).
.
page 12 (power
page 12 (injecteur PoE).
Power Connector on page 9
4