Troubleshooting - CanyCom MASAO CMX227 Operator's Manual

Troubleshooting

• If any malfunction or abnormal condition is found, immediately stop using the machine
and take an appropriate measure according to the Troubleshooting chart below. If the
malfunction or abnormal condition is not listed in the chart, or the suggested measure
does not solve the problem, consult with your CANYCOM representative.
• Some corrective measures listed below require special knowledge and/or equipment.
Please contact your CANYCOM representative in such a case.
Area
Engine does not start, or
is difficult to start
Engine
Oil pressure warning
light stays on
Engine stalls.
Troubleshooting
Malfunction
Out of fuel.
Excessive fuel in the
engine.
Battery capacity is
insufficient.
Battery cable is
disconnected.
Insufficient or wrong oil.
Dirty or damaged spark
plug.
Other (other than the
above).
Insufficient amount of oil. →Fill oil.
Other (other than the
above).
Out of fuel.
Choke valve closed.
Other (other than the
above).
Possible Cause
→Fill fuel.
→Wait a while and try
→Add battery fluid.
→Charge battery.
→Replace battery.
→Connect battery cable.
→Fill or change oil.
→Clean or replace spark
→Follow the instructions
→Please contact
→Fill fuel.
→Open choke valve.
→Please contact
-87-
Corrective Measure
starting again.
plug.
in "Starting" to restart.
If problem persists,
please contact
your CANYCOM
representative.
your CANYCOM
representative.
your CANYCOM
representative.
6
Ref.
Page 17
Page 78
Page 78
Page 59
Page 62
Page 27
Page 60
Page 17