Dell PowerEdge C6320 Owner's Manual page 111

5. SATA2 hard drive connectors 1 to 6 for
system board 2 (from right to left)
7. SGPIO connector A for system board 1
9. SGPIO connector A for system board 2
11. SGPIO connector A for system board 3
13. SGPIO connector A for system board 4
15. backplane power connector for power
supply unit 2
5. Disconnect front panel cables from the power distribution board.
NOTE: Observe the routing of the cable on the chassis as you remove them from the system.
You must route these cables properly when you replace them to prevent the cables from being
pinched or crimped.
6. Remove the screws that secure the hard-drive cage to the chassis.
Figure 85. Removing and installing the direct backplane
1. hard drive cage
7. Remove the screws that secure the front-panel assemblies to the chassis.
8. Remove the hard-drive cage from the chassis.
6. SATA2 hard drive connectors 1 to 6 for
system board 1 (from right to left)
8. SGPIO connector B for system board 1
10. SGPIO connector B for system board 2
12. SGPIO connector B for system board 3
14. SGPIO Connector B for system board 4
2. screw (2)
111