Installing The Sensor Board For 2.5 Inch Hard-Drive System; Cable Routing For Sensor Board And Front Panel For 2.5 Inch Hard Drive System - Dell PowerEdge C6320 Owner's Manual
Hide thumbs
Also See for PowerEdge C6320:
- Getting started (201 pages) ,
- Owner's manual (183 pages) ,
- Getting started manual (137 pages)
Table of Contents
Advertisement
Installing the sensor board for 2.5 inch hard-drive system
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Replace the sensor board into the sensor-board holder.
2.
Replace the sensor board assembly into the hard drive cage.
3.
Replace the screw that secures the sensor board to the hard drive cage.
4.
Connect the sensor board cable to the sensor board.
5.
Replace the hard drive cage into the chassis.
6.
Replace the screws that secure the hard-drive cage to the chassis.
7.
Connect all the cables to the backplane.
NOTE: You must route these cables properly on the chassis to prevent them from being
pinched or crimped.
8.
Connect the front panel cables to the power distribution board.
NOTE: You must route these cables properly on the chassis to prevent them from being
pinched or crimped.
9.
Close the system.
10. Replace the hard drives.
11. Reconnect the system to its electrical outlet and turn on the system, including any attached
peripherals.
Related Information
Closing the system
Installing a hard drive into a hard-drive carrier
Cable routing for sensor board and front panel for 2.5 inch hard drive system
1.
Connect the Y-shaped cable for the sensor board and front panel 2 to the connector on the power
distribution board 1, and connect the other two ends of the cable to the connectors on the sensor
board and the front panel 2 respectively.
2.
Connect the front panel cable to the connector on the power distribution board 1, and connect the
other end of the cable to the connector on the front panel 1.
125
Advertisement
Table of Contents
Troubleshooting
