Dell PowerEdge C6320 Owner's Manual page 90

WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. See your
safety information for additional information.
1. Remove the system-board assembly.
2. Remove the air baffle.
3. Remove the expansion-card assembly.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector
while installing or removing a battery.
4. Gently lift the battery out of the connector.
5. Hold the new battery with the "+" facing the positive side of battery connector.
6. Insert the battery into the battery holder until it is seated in place.
Figure 59. Replacing the system battery
1. system battery
3. negative side of battery connector
7. Replace the system-board assembly.
8. Enter the System Setup program to confirm that the battery is operating properly. See
System Setup.
9. Enter the correct time and date in the System Setup program's and Time and Date fields.
10. Exit the System Setup program.
Related Information
Removing a system-board assembly
Removing the air baffle
Removing the expansion card for 1U node
Installing a system-board assembly
90
2. positive side of battery connector
Entering