System-Board Assembly; Removing A Dummy System-Board Tray - Dell PowerEdge C6320 Owner's Manual

CAUTION: The System requires at least one power supply unit to operate normally.
1. Verify that both power supply units are of the same type and have the same maximum output power.
NOTE: The maximum output power is printed on the power supply unit label.
2. Slide the new power supply unit into the chassis until the power supply until is fully seated and the
release lever snaps into place.
3. Connect the power cable to the power supply unit and plug the cable into a power outlet.
NOTE: When installing a new power supply unit in a system with two power supply units, allow
several seconds for the system to recognize the power supply unit and determine its status.

System-board assembly

Removing a dummy system-board tray

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Remove the screw that secures the retaining latch.
2. Press the retaining latch and slide the dummy system-board tray out of the chassis.
Figure 36. Removing and installing a dummy system-board tray
1. retaining latch
3. dummy system-board tray
2. screw
63