9-62 Upgrading Your Server
Internal USB Floppy Disk Drive
Your server can contain an internal USB floppy disk drive.
Installation
Follow steps below to install an internal USB floppy disk drive.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover and open the front mask.
3.
Remove the two fixing screws and remove the dummy panel for floppy disk drive.
Fixing screw
Dummy panel
Fixing screw
IMPORTANT:
carefully.
4.
Insert the internal USB floppy disk drive into the bay slowly and carefully. See the figure
below.
Keep the removed dummy panel and fixing screws