Table of Contents
Advertisement
Optical Disk Drive
The server is provided with the optical disk drive on its front to read/write data from/to a disc.
Setting and Removing the Disc
1.
Make sure that the power of the server is on (with the POWER/SLEEP lamp being lit in
green) before setting the disc on the optical disk drive.
2.
Press the Open/Close button on the front of the optical disk drive.
The tray comes out.
3.
Put the disc on the tray carefully and securely with the character printed surface facing
upward.
4.
Press the Open/Close button or gently push on the tray front.
The tray is automatically retracted into the optical disk drive.
IMPORTANT: If a noisy sound in driving the optical disk drive occurs
after setting a disc, set it again correctly.
To take out the disc from the optical disk drive, press the Open/Close button in the similar way in
setting the disc to make the tray go out. If the access LED is lit, the disc is being accessed. Confirm
that the access LED is not lit before pressing the Open/Close button.
Your OS may have a command to eject the tray.
When you have taken out the disc, retract the tray back in place.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-9 for details.
Do not leave the tray ejected from the optical disk drive.
Take off the headphone before you plug in the headphone jack.
CAUTION
General Description 2-23
Advertisement
Table of Contents
