Table of Contents
Advertisement
5.
Secure the device to be installed to the rail with two screws provided with the device.
6.
Slowly insert the device into additional slot 1 with the release tabs on both sides of the file
bay pushed.
Push the file bay until a click occurs to lock it.
7.
Connect the interface and power cables to the 5.25-inch device installed from one side of
the server.
See Chapter 10 for details.
8.
Install the removed components.
9.
Set the parameters including the transfer rate using the BIOS utility of the SCSI controller.
Refer to the manual provided with the SCSI controller for details.
10.
Install the device driver for the installed device.
Refer to the manual provided with the device for details.
Removal
The file device can be removed in the reverse order of the installation. If the device is removed but
not installed again, install the dummy cover.
Upgrading Your Server 9-59
Advertisement
Table of Contents
