Table of Contents
Advertisement
9-42 Upgrading Your Server
6.
Close the levers securely.
7.
Install the duct cover you have removed, and secure it with a setscrew.
8.
Install the left side cover you have removed.
9.
Turn on the power of the server. Make sure that no error message appears in the POST.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 8.
10.
Run the BIOS SETUP and select [Advanced] → [Memory Configuration] to verify that
the installed DIMM shows the status "Normal". (See Chapter 4 for details.)
11.
Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This is required to update the hardware configuration information. See Chapter 4 for
details.
12.
If Windows Server 2003 is in use, set the paging file size to the recommended value or a
greater value. See Chapter 5 for details.
Advertisement
Table of Contents
