Internal Usb Floppy Disk Drive - NEC N8100-1422F User Manual

Internal USB Floppy Disk Drive

Your server can contain an internal USB floppy disk drive.
Installation
Follow steps below to install an internal USB floppy disk drive.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover and open the front mask as described earlier in this chapter.
3.
Remove the two fixing screws and remove the dummy panel for floppy disk drive.
Dummy panel
IMPORTANT:
carefully.
4.
Insert the internal USB floppy disk drive into the bay slowly and carefully. See the figure
below.
Save the removed dummy panel and fixing screws
Upgrading Your Server 9-49
Fixing screws