Table of Contents
Advertisement
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2.
Remove the left side cover (see Chapter 9).
3.
Change jumper switch setting from "Protect" to "Clear".
4.
After five seconds later, reinstall the jumper.
5.
Reassemble the server.
6.
Connect the power cord and then press the POWER switch to turn on the server.
7.
Press F2 during POST to run the BIOS Setup utility, and execute [Load Setup Defaults]
on the Exit menu.
Clearing Password
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2.
Remove the left side cover (see Chapter 9).
3.
Change jumper switch setting from "Protect" to "Clear".
4.
Reassemble the server, and press the POWER switch to turn on the server.
5.
Press F2 during POST to run the BIOS Setup utility, set the password again, and execute
[Exit Saving Changes] on the Exit menu.
Configuring Your Server 4-107
Advertisement
Table of Contents
