Table of Contents
Advertisement
5-60 Installing the Operating System with Express Setup
9.
On the [Paging file size for each drive] box, specify as follows:
– A value larger than the recommended size shown in [Total paging file size for all
drives] for [Initial size]
– A value larger than the [Initial size] for [Maximum size]
Then click [Set].
IMPORTANT:
The above-mentioned paging file size is recommended for
collecting debug information (memory dump). The paging file
with initial size large enough to store the dump file in the boot
drive is required.
Correct debug information might not be able to be collected due to
virtual memory shortage when the paging file is insufficient, so set
an enough size of the paging file with the entire system.
For more information on "Recommended" value, see "About the
System Partition Size" described earlier.
In case the memory is expanded, re-specify the paging file to suit
the new memory size.
10.
Click [OK].
The message to restart the system may appear according to the modified specification.
In such case, follow the message to restart the system.
When the system is Windows Server 2003
Follow the procedure below to specify.
1.
Select [Control Panel] and click [System].
The [System Properties] dialog box appears.
2.
Select [Advanced] tab.
3.
Click [Settings] on the [Startup and Recovery] group box.
Advertisement
Table of Contents
