Table of Contents
Advertisement
6-3
Removing the Power Cord
Before performing any setup or maintenance on the chassis, use the following
procedure to ensure that power has been removed disconnected from the system.
Removing the Power Cord
1. Use the operating system to power down the system, following the on-screen
prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply.
3. If your system has dual redundant power supplies, remove the cords from
both power supplies.
4. Disconnect the cord from the power strip or wall outlet.
6-4
Installing and Removing the Node Drawers
The SCF418IL chassis contains eight individual motherboards in separate node
drawers (Figure 6-2). Each motherboard node controls a set of two hard drives.
Note that if a motherboard node drawer is pulled out of the chassis, the hard drives
associated with that node will power down as well.
Figure 6-2: Hard Drives and the Corresponding Motherboards
Chapter 6: Advanced Chassis Setup
6-3
Advertisement
Table of Contents
