Table of Contents
Advertisement
Chassis Setup and Maintenance
5-1
Overview
This chapter covers the steps required to install components and perform mainte-
nance on the chassis. The only tool required is a Phillips screwdriver.
Review the warnings and precautions listed in the manual before setting up or
servicing this chassis. These include information in Chapter 2: System Safety and
the warning/precautions listed in the setup instructions
When coupled with an SAS-833TQ backplane, this chassis is capable of failover
and cascading. Review Appendix C in this manual for setup instructions.
5-2
Removing the Power Cord
Before performing most setup or maintenance tasks, use the following procedure
to ensure that power has been removed from the system.
1. Use the operating system to power down the system, following the on-screen
prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply. If your system
has dual power supplies, remove the cords from both power supplies.
3. Disconnect the cord from the power strip or wall outlet.
Chapter 5
5-1
Chapter 5: Chassis Setup
Advertisement
Table of Contents
