Table of Contents
Advertisement
FatTwin F617R2-FT/F73 USER'S MANUAL
5-2
Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed in preconfi gured systems to prevent them from blocking the fl ow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are confi guring the system, keep the airfl ow in mind when routing the cables.
The following cables need to be connected for the FatTwin F617R2-FT/F73 system:
•
F617R2-FT only:
Sixteen (16) 29-cm 30AWG SATA cables (CBL-0483L)
F617R2-F73 only:
Sixteen (16) 21-cm 30AWG SATA cables (CBL-0473L)
5-3
I/O Ports
The rear I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-1 below for the colors and locations of the various I/O ports.
1
Figure 5-1. Rear I/O Ports
2
3
4
Back Panel I/O Port Locations and Defi nitions
1.
Front Panel USB Port 1
2.
Front Panel USB Port 2
3.
Gigabit LAN 1
4.
Gigabit LAN 2
5.
IPMI LAN
6.
VGA Port
7
Power Switch LED
5
6
5-2
7
Advertisement
Table of Contents
