To Activate; To Set A Desired Speed; To Deactivate; To Resume Speed - Dodge Challenger SRT 392 2015 Operating Information Manual

button and resetting the desired vehicle set
speed.

To Activate

Push the ON/OFF button to activate the elec-
tronic speed control. CRUISE CONTROL
READY will appear on the instrument cluster to
indicate the electronic speed control is on. To
turn the system off, push the ON/OFF button a
second time. CRUISE CONTROL OFF will ap-
pear on the instrument cluster to indicate the
electronic speed control is off. The system
should be turned off when not in use.
WARNING!
Leaving the Electronic Speed Control sys-
tem on when not in use is dangerous. You
could accidentally set the system or cause it
to go faster than you want. You could lose
control and have an accident. Always leave
the system OFF when you are not using it.
84

To Set A Desired Speed

Turn the Electronic Speed Control ON. When
the vehicle has reached the desired speed,
press the SET (+) or SET (-) button and release.
Release the accelerator and the vehicle will
operate at the selected speed. Once a speed
has been set a message CRUISE CONTROL
SET TO MPH (km/h) will appear indicating what
speed was set. A CRUISE indicator lamp, along
with set speed will also appear and stay on in
the instrument cluster when the speed is set.

To Deactivate

A soft tap on the brake pedal, pushing the
CANCEL button, or normal brake pressure
while slowing the vehicle will deactivate the
Electronic Speed Control without erasing the
set speed from memory.
Pressing the ON/OFF button or turning the
ignition switch OFF erases the set speed from
memory.

To Resume Speed

To resume a previously set speed, push the
RES (+) button and release. Resume can be
used at any speed above 20 mph (32 km/h).

To Vary The Speed Setting

To Increase Speed
When the Electronic Speed Control is set, you
can increase speed by pushing the SET +
button.
The drivers preferred units can be selected
through the instrument panel settings if
equipped. Refer to "Understanding Your Instru-
ment Panel" for more information. The speed
increment shown is dependant on the chosen
speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pressing the SET + button once will result in
a 1 mph increase in set speed. Each subse-
quent tap of the button results in an increase
of 1 mph.
• If the button is continually pressed, the set
speed will continue to increase until the but-
ton is released, then the new set speed will
be established.