Dodge Challenger SRT 392 2015 Operating Information Manual page 81

NOTE:
The Headlight Time Delay is programmable
using the Uconnect® System, refer to
"Uconnect® Settings" in "Understanding
Your Instrument Panel" for further informa-
tion.
Daytime Running Lights (DRL) — If
Equipped
The Daytime Running Lights will turn On when
the engine is started and remain On unless the
headlamps are turned ON, the parking brake is
applied, or the engine is shut Off.
NOTE:
If allowed by law in the country in which the
vehicle was purchased the Daytime Running
Lights can be turned on and off using the
Uconnect® System, refer to "Uconnect®
Settings" in "Understanding Your Instru-
ment Panel" for further information.
Lights-On Reminder
If the headlights or parking lights are on after the
ignition is placed in the OFF position, a chime
will sound to alert the driver when the driver's
door is opened.
78
Multifunction Lever
The multifunction lever controls the operation of
the turn signals, headlight beam selection and
passing lights. The multifunction lever is located
on the left side of the steering column.
Multifunction Lever
Turn Signals
Move the multifunction lever up or down and the
arrows on each side of the instrument cluster
flash to show proper operation of the front and
rear turn signal lights.
NOTE:
• If either light remains on and does not
flash, or there is a very fast flash rate,
check for a defective outside light bulb. If
an indicator fails to light when the lever is
moved, it would suggest that the indicator
bulb is defective.
• A "Turn Signal On" message will appear
in the Drivers Information Display (DID)
and a continuous chime will sound if the
vehicle is driven more than 1 mi (1.6 km)
with either turn signal on.
Lane Change Assist
Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically turn
off.
High/Low Beam Switch
Push the multifunction lever away from you to
switch the headlights to high beam. Pull the
multifunction lever toward you to switch the
headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever