If the system is Set when the vehicle speed is
above 19 mph (30 km/h), the Set Speed shall
be the current speed of the vehicle.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to accel-
erate beyond the set speed. If this occurs:
• The message "DRIVER OVERRIDE" will dis-
play in the DID.
• The system will not be controlling the dis-
tance between your vehicle and the vehicle
ahead. The vehicle speed will only be deter-
mined by the position of the accelerator
pedal.
To Cancel
The following conditions cancel the system:
• The brake pedal is applied.
• The CANCEL button is pressed.
• The vehicle speed goes below 15 mph
(24 km/h).
• An Anti-Lock Brake System (ABS) event
occurs.
• The shift lever/gear selector is removed from
the Drive position.
• The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
• The vehicle parking brake is applied.
• A Trailer Sway Control (TSC) event occurs.
• The driver switches ESC to full-off mode.
To Turn Off
The system will turn off and erase the set speed
in memory if:
• The Normal (Fixed Speed) Electronic Speed
Control ON/OFF button is pressed.
• The ignition is turned off.
• The Adaptive Cruise Control (ACC) On/Off
button is pressed.
To Resume
If there is a set speed in memory press the RES
(resume) button and then remove your foot from
the accelerator pedal. The DID will display the
last set speed.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
To Vary The Speed Setting
To Increase Speed
While ACC is set, you can increase the set
speed by pressing the SET + button.
The drivers preferred units can be selected
through the instrument panel settings if
equipped. Refer to " Understanding Your Instru-
ment Panel" for more information. The speed
increment shown is dependant on the chosen
speed unit of U.S. (mph) or Metric (km/h):
89