Jump-Starting Procedures; Preparations For Jump-Start - Dodge Challenger SRT 392 2015 Operating Information Manual

Hide thumbs Also See for Challenger SRT 392 2015:
Table of Contents

Advertisement

WARNING!
To avoid the risk of forcing the vehicle off the
jack, do not tighten the lug nuts fully until the
vehicle has been lowered. Failure to follow
this warning may result in personal injury.
3. Lower the vehicle to the ground by turning
the jack handle counterclockwise.
4. Refer to Torque Table for proper lug nut
torque.
5. After 25 miles (40 km) check the lug nut
torque with a torque wrench to ensure that
all lug nuts are properly seated against the
wheel.
JUMP-STARTING
PROCEDURES
If your vehicle has a discharged battery it can be
jump-started using a set of jumper cables and a
battery in another vehicle or by using a portable
battery booster pack. Jump-starting can be dan-
gerous if done improperly so please follow the
procedures in this section carefully.
246
NOTE:
When using a portable battery booster pack
follow the manufacturer's operating instruc-
tions and precautions.
CAUTION!
Do not use a portable battery booster pack or
any other booster source with a system
voltage greater than 12 Volts or damage to
the battery, starter motor, alternator or elec-
trical system may occur.
WARNING!
Do not attempt jump-starting if the battery is
frozen. It could rupture or explode and cause
personal injury.

Preparations For Jump-Start

The battery is stored under an access cover in
the trunk. Remote battery posts are located on
the right side of the engine compartment for
jump-starting.
Remote Battery Posts Locations
1 — Remote Positive (+) Post
2 — Remote Negative (-) Post
WARNING!
• Take care to avoid the radiator cooling fan
whenever the hood is raised. It can start
anytime the ignition switch is ON. You can
be injured by moving fan blades.
(Continued)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Challenger srt hellcat 2015

Table of Contents