Dodge Challenger SRT 392 2015 Operating Information Manual page 180

3. If you wish to stop the cranking of the engine
prior to the engine starting, release the
button.
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or
pressing the accelerator pedal.
To Turn Off The Engine Using ENGINE
START/STOP Button — Automatic
Transmission Only
1. Place the shift lever in PARK, then press and
release the ENGINE START/STOP button.
2. The ignition switch will return to the OFF
position.
3. If the shift lever is not in PARK, the ENGINE
START/STOP button must be held for two
seconds and vehicle speed must be above
5 mph (8 km/h) before the engine will shut
off. The ignition switch position will remain in
the ACC position until the shift lever is in
PARK and the button is pressed twice to the
OFF position. If the shift lever is not in PARK
and the ENGINE START/STOP button is
pressed once, the Driver Information Display
(DID) will display a "VEHICLE NOT IN
PARK" message and the engine will remain
running. Never leave a vehicle out of the
PARK position, or it could roll.
NOTE:
If the ignition switch is left in the ACC or
RUN (engine not running) position and the
transmission is in PARK, the system will
automatically time out after 30 minutes of
inactivity and the ignition will switch to the
OFF position.
To Turn Off The Engine Using ENGINE
START/STOP Button — Manual
Transmission Only
1. With the vehicle stopped, place the shift
lever in NEUTRAL, then press and release
the ENGINE START/STOP button.
2. The ignition switch will return to the OFF
position.
3. Place the shift lever in first gear or RE-
VERSE and then apply the parking brake.
NOTE:
• If the ignition switch is left in the ACC
position, the system will automatically
time out after 30 minutes of inactivity and
the ignition will switch to the OFF posi-
tion.
• If the ignition switch is left in the RUN
position, the system will automatically
time out after 30 minutes of inactivity if
the vehicle speed is 0 mph (0 km/h) and
the engine is not running.
• If the vehicle speed is above 5 mph
(8 km/h), the ENGINE START/STOP button
must be held for two seconds before the
engine will shut off. The ignition switch
position will remain in the ACC position
until the vehicle is stopped and the button
is pressed twice to the OFF position.
Keyless Enter-N-Go™ Functions — With
Driver's Foot OFF The Brake Pedal/Clutch
Pedal (In PARK Or NEUTRAL Position)
The Keyless Enter-N-Go™ feature operates
similar to an ignition switch. It has three posi-
tions, OFF, ACC and RUN. To change the
ignition switch positions without starting the
177