Dodge Challenger SRT 392 2015 Operating Information Manual page 195

NOTE:
Pushing the SRT button on the center stack
or pressing the "SRT & Apps" button on the
touchscreen are two other options to access
launch control features. Please refer to
"Uconnect® Settings" within your Owner's
Manual on the DVD for further information.
2. Press the "Launch RPM Set-Up" button on
the touchscreen. This screen will allow you
to adjust your launch RPM's for optimum
launch/traction.
3. Press the "Activate Launch Mode" button on
the touchscreen.
4. Make sure the vehicle is not moving.
5. Make sure the steering wheel is pointing
straight.
6. Hold the brake and make sure the vehicle is
in "Drive".
7. While holding the brake, rapidly apply the
accelerator pedal to wide open throttle. The
engine speed will hold at the RPM that was
set in the "Launch RPM Set-up" screen.
192
NOTE:
Messages will appear in the Driver Informa-
tion Display (DID) to inform the driver if one
or more of the above conditions have not
been met.
8. When conditions 5 through 8 have been met,
the Driver Information Display (DID) will read
"Launch Ready Release Brake".
9. Keep the vehicle pointed straight.
Launch control will be active until the vehicle
reaches 62 mph (100 km/h), at which point the
ESC system will return to its current ESC mode.
Launch control will abort before launch comple-
tion, display "Launch Aborted" in the cluster
under any the following conditions:
• The accelerator pedal is released during
launch.
• The ESC system detects that the vehicle is
no longer moving in a straight line.
• The "ESC OFF" button is pressed to change
the system to another mode.
NOTE:
After launch control has been aborted, ESC
will return to its current ESC mode.
Manual Transmission — If Equipped
Vehicles with a manual transmission have an
adjustable launch RPM controlled through the
Uconnect® system.
Launch Control is only available when the fol-
lowing procedure is followed:
1. Pressing the "LAUNCH" button on the center
stack switch bank.
NOTE:
Pushing the SRT button on the center stack
or pressing the "SRT & Apps" button on the
touchscreen are two other options to access
launch control features. Please refer to
"Uconnect® Settings" within your Owner's
Manual on the DVD for further information.
2. Press the "Launch RPM Set-Up" button on
the touchscreen. This screen will allow you
to adjust your launch RPM's for optimum
launch/traction.