Rps > [2] Rps Phone Number Menu Parameters; Rps > [3] Rps Ip Address Menu Parameters - Bosch B5512 Reference Manual

120 en | Keypad Installer menu
19.1.10 [3] RPS > [2] RPS Phone Number menu parameters
The RPS Phone Number is the number the control panel dials to contact RPS. In this menu,
you can program the RPS phone number.
RPS Phone Number
B91x/B92x keypads configuration of RPS Phone Number
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of RPS Phone Number
1.
2.
3.
4.
5.
6.
7.
19.1.11 [3] RPS > [3] RPS IP Address menu parameters
The control panel can use a network hostname or an IPv4 address to call RPS. In this menu,
you can program the IPv4 address or hostname for RPS communication.
RPS IP Address
B91x/B92x keypads configuration of RPS IP Address
1.
2.
3.
4.
5.
6.
7.
B93x/B94x keypads configuration of RPS IP Address
1.
2.
3.
4.
5.
6.
2015.07 | 12 | F.01U.287.180
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [2] RPS Phone Number.
Press [ENTER] to edit RPS phone number.
Delete existing numbers, if necessary, and then enter the new numbers.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [2] RPS Phone Number.
Press [Edit] to change the phone number.
Delete existing number, if necessary, and then enter the new number.
Press [ENTER] to save the phone number.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [3] RPS IP Address.
Press [ENTER] to edit RPS IP address.
Use [PREV] or [NEXT] to toggle between the option to edit the address as an IPv4
address or as a hostname. Press [ENTER] when the keypad shows the option you want to
edit.
Delete existing characters, if necessary, and then enter the new characters. Use [PREV]
or [NEXT] to move to a different byte (group of digits).
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [3] RPS IP Address.
Press [Edit as IPv4] for an IP address, or the [Edit as Name] for a hostname.
Delete existing characters, if necessary, and then enter the new characters. Use [PREV]
or [NEXT] to move to a different byte (group of digits).
For an IPv4 address, use
the number keys to enter the new numbers. For a hostname, press a number key
repeatedly to scroll through the number and letters shown on the key.
Press [Save] to save the programming.
Installation and System Reference Guide
/[PREV] or /[NEXT] to move to a different byte, and use
Control Panel
Bosch Security Systems, Inc.