Phone Number Programming - Bosch Solution 64 Installer's Manual

Solution 64 | Installer Guide | Comms Programming
Domestic Phone Number 2
86538_
Press  0-9 OK to SAVE
5) When the second number is complete press [OK] to program
telephone number 3 if required.
Domestic Phone Number 3
73653_
Press  0-9 OK to SAVE
When finished press [OK] to save and exit or press [MENU] to
7)
cancel.
Comms > Commands >
Call / Answer
(SolutionLink)
This command allows you to initiate a modem call to an off-site
computer for programming changes or updates. The off-site
computer must be connected to the telephone line that is
programmed in the call back telephone number and be set to
wait for an incoming call from the same customer that initiates
the modem call.
If the phone is ringing and this command is enetered, then the
panel will answer the call and attempt to start a SolutionLink
RAS session.
Comms > Commands >
Call Forward On/Off
This command allows you to turn on and off the call forward
feature. When you turn on call forwarding, the panel will
automatically activate and de-activate the call forward on and
call forward off sequence accordingly when you turn Area 1 All
On and Off (arm and disarm).
1) Enter [MENU] + [5] + [0] + [2]. If the call forward status is OFF,
the keypad will display:
Call Forward On/Off
Call Forward is OFF
To turn ON, Press ON
To Go Back Press OK
If the call forward status is ON, the keypad will display:
2)
Call Forward On/Off
Call Forward is ON
To Turn OFF, Press OFF
To Go Back Press OK
3) To toggle call forward on, press the [ON] key or press the [OFF]
key to turn call forward off.
Press [OK] to save and exit, or press [MENU] to cancel.
4)
9-2
RAS
- -
MENU 5-0-1
  
-
MENU 5-0-2
 
i
See MENU 5-1-6 and MENU 5-1-7 to program the Call Forward
ON and Call Forward OFF number sequence.
Note
Comms > Commands >
Check Web Email
Reserved
Comms > Commands >
Email System Log
Reserved
Ph on e N umbe r Prog ramming
Comms > Telephone Number >
Number Prefix
1
The number prefix allows you to program the customer
account number and pass code (PIN) to access the telephone
line exchange when using a pre-paid telephone account
(e.g. Telstra Communic8 Pre-Paid Home account), or when a
number followed by a pause is required to get an outside line
on a PABX system.
The number prefix is global for all telephone numbers
programmed in both Destination 1 and Destination 2
(including the domestic telephone numbers and call forward
sequences). the prefix will be dialled immediately before the
number.
1) Enter [MENU] + [5] + [1] + [0]. The keypad will display the
current Telco Number Prefix.
Number Prefix P001
Press  0-9 OK to SAVE
2) Using the numeric keys, enter all the digits of the telephone
number prefix. You can change a single digit by scrolling the
cursor left or right. For special characters including, pause, *
or #, use the up and down arrow keys.
Press [OK] to save and exit or press [MENU] to exit without
3)
saving.
Comms > Telephone Number >
Primary Dest 1
1
This menu sets the primary telephone number for Report
Destination 1. This will typically be the primary base station
receiver number.
-
MENU 5-0-3
 
-
MENU 5-0-4
 
MENU 5-1-0

Digits
MENU 5-1-1

Digits
Bosch Security Systems | 11/05 | BLCC110I
32
32