Bosch B5512 Reference Manual page 102

102 en | Keypad Installer menu
Figure 19.1: RESET button and Heartbeat LED location (B5512 shown)
Accessing SERVICE MODE (rapid pulsing Heartbeat LED):
1.
2.
Exiting SERVICE MODE and returning to normal operation (slow pulsing Heartbeat LED):
Press and hold the control panel RESET button for approximately 5 seconds until the
Heartbeat LED turns off. The control panel resets.
Conventions for this section
This guide to the keypad Installer menu provides instructions for using the keypad, based on
the following conventions:
–
–
–
–
–
2015.07 | 12 | F.01U.287.180
Press and hold the control panel RESET button until the Heartbeat LED flashes fast. The
keypad shows SERVICE MODE and prompts for the installer passcode.
Enter your installer passcode and press [ENTER].
All instructions access the Installer menu from the Main menu (Installer) option, not while
in Service mode.
This section covers all compatible keypads. It provides specific steps for each keypad
style.
Keys to press appear in this manual in brackets [ ].
For simplicity, the keypad Installer menu tree and instructions combine the two-line
keypad number selections with the text and graphic steps of other keypads. For example,
rather than indicating that the two-line keypad reads Press [2] for enhanced comm
parameters, and that a different keypad reads Enhanced Comm Parms, this section
indicates the selection as [2] Enhanced Comm Parms.
For simplicity and readability of instructions, this section lists menu steps in succession
with the > character separating steps. For example, Go to [1] Program > [1] Reporting >
[2] Network > [2] Enhanced Comm Parms.
Installation and System Reference Guide
100BASE-T
LINK
ON-BOARD POINTS
Voltage Ranges
Open 3.7 - 5.0 VDC
OUTPUT
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
3 COM 4 5 COM 6 7 COM 8
3 COM 4 5 COM 6 7
ETHERNET
USB
C
B
COM 8
Bosch Security Systems, Inc.
Control Panel