Rps > [1] Rps Passcode Menu Parameters - Bosch B5512 Reference Manual

Control Panel
2.
3.
4.
5.
6.
SIM PIN
B91x/B92x keypads configuration of SIM PIN
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of SIM Passcode
1.
2.
3.
4.
5.
6.
19.1.9 [3] RPS > [1] RPS Passcode menu parameters
The control panel verifies the remote programming software at the central station has valid
access before connecting using the RPS passcode. In this menu, you can program the RPS
passcode.
RPS Passcode
B91x/B92x keypads configuration of RPS Passcode
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of RPS Passcode
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [3] SIM Passcode. The keypad shows the UPnP current configuration.
Press [Edit] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [4] SIM PIN. The keypad shows the current configuration.
Press [ENTER] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the changes.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [4] SIM PIN. The keypad shows the UPnP current configuration.
Press [Edit] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [1] RPS Passcode.
Press [ENTER] to edit RPS passcode.
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [1] RPS Passcode.
Press [Edit] to change the passcode.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Installation and System Reference Guide
Keypad Installer menu | en
2015.07 | 12 | F.01U.287.180
119