Wireless Modules; B810 Receiver; Sdi2 Address Settings; Supervision - Bosch B5512 Reference Manual

Control Panel
14

Wireless modules

The control panel supports one B810 or one B820 for wireless sensors for easy and flexible
installation.
14.1

B810 receiver

The B810 is a wireless receiver that supports the full line of RADION wireless devices and the
RADION repeater. The receiver supports up to 504 wireless point devices, up to 1000 keyfobs,
and up to 8 repeaters.
Connect a RADION receiver SD to the SDI2 bus on the control panel using terminals PWR, A,
B, and COM. This section includes basic installation instructions. Refer to the RADION receiver
SD (B810) Installation Guide for detailed installation instructions.
14.1.1

SDI2 address settings

Notice!
The module reads the address switch setting only during module power up. If you change the
setting after you apply power to the module, you must cycle the power to the module in order
for the new setting to take effect.
The control panel supports only address 1.
14.1.2

Supervision

The control panel enables supervision of the module when you enroll at least one RF device.
Available RF devices on the control panel include RF Repeaters, wireless points, or user
keyfobs. Any failure to receive an expected response from an SDI2 module results in a system
fault display on all keypads and a fault event sent to the central station.
14.1.3

Installation and control panel wiring (B810)

Ensure that there is enough power for the module and other powered devices you want
connected to the system.
Refer to On-board outputs, page 58.
Caution!
! Remove all power (AC and battery) before making any connections. Failure to do so might
result in personal injury and/or equipment damage.
Install the module
For best receiver reception results, place the receiver in a central location among the
transmitters.
1.
2.
3.
4.
5.
Notice!
Mount the receiver in a location removed from metal. Metal objects (duct work, wire mesh
screens, boxes) reduce RF range.
Bosch Security Systems, Inc.
Open the module.
Set the module to address 1 using the address switch.
Use the provided anchors and screws to mount the module base on the wall.
Pull the necessary wiring through the mounting plate. Refer to Wire to the control panel
(B810).
Install the module on the base.
Installation and System Reference Guide
Wireless modules | en 71
2015.07 | 12 | F.01U.287.180