Rps > [1] Rps Passcode Menu Parameters; Rps > [2] Rps Phone Number Menu Parameters - Bosch B9512G Installation And System Reference Manual

134 en | Keypad Installer menu
4.
5.
6.
B93x/B94x keypads configuration of SIM Passcode
1.
2.
3.
4.
5.
6.
20.1.9 [3] RPS > [1] RPS Passcode menu parameters
The control panel verifies the remote programming software at the central station has valid
access before connecting using the RPS passcode. In this menu, you can program the RPS
passcode.
RPS Passcode
B91x/B92x keypads configuration of RPS Passcode
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of RPS Passcode
1.
2.
3.
4.
5.
6.
20.1.10 [3] RPS > [2] RPS Phone Number menu parameters
The RPS Phone Number is the number the control panel dials to contact RPS. In this menu,
you can program the RPS phone number.
RPS Phone Number
B91x/B92x keypads configuration of RPS Phone Number
1.
2.
3.
4.
5.
6.
2016.06 | 08 | F.01U.303.996
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the changes.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [4] SIM PIN. The keypad shows the UPnP current configuration.
Press [Edit] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [1] RPS Passcode.
Press [ENTER] to edit RPS passcode.
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [1] RPS Passcode.
Press [Edit] to change the passcode.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [3] RPS > [2] RPS Phone Number.
Press [ENTER] to edit RPS phone number.
Delete existing numbers, if necessary, and then enter the new numbers.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Installation and System Reference Guide
Control Panels
Bosch Security Systems, Inc.