Installing The Job Separator (Option) - Kyocera Mita KM-3530 Service Manual

1-3-15 Installing the job separator (option)

Preparation
1. Open the conveying cover and the front
cover.
2. Loosen the two left screws on the left side,
remove the screw on the front side, open the
hook on the right side, and remove the left
front cover.
3. Close the conveying cover and the front
cover.
4. Remove the two screws and remove the
ejection cover with the mounting plate.
5. Remove the two screws and then remove the
inner ejection cover.
Left front
cover
Screws
Figure 1-3-121
Ejection cover
Figure 1-3-122
Screws
Figure 1-3-123
2BH/J
Hook
Screw
Screws
Inner ejection
cover
1-3-55